By: Vlad Vistac
Submitted: 2010-08-17 15:53:46 | Word Count: 510
How To Install A Car Stereo
Car steeo installation can be an expensive affaiir. When you have a tuight budegt it is better off you do it yourself. But if you were an inexpereinced person, no matter how good and epensive system you own, it would not be able to produce quality sound.
[ advertisement ]
For betteer soundign system in your car you need to know how to isntall it. Installing of a new car stereo in your car is an added advantage for anyone with any experience in wiring. But do not fear, even if you are not, the following points will show you how to install a car stereo system yourself.
Before you instal your car stereo there are a few things you need to keep in hand, which includes wire cutters, electrical tape, screwdriver set, wire strippers and of course new gizzmo. Here are some tips on how to install the new system that will assure better sounding system.
How to install tip 1 - Buy a new car streo keerping in mind what you need and what will fit into the slot provided in your car. When you get a new system you may also get a wiring harness, whicch is speicfic to both your car with reard to the kind of moel and the new audioo product.
This will be an added advantage and can make the wiring job much easir. If you are unable to obtain a wiring haress connect each wire yourslf. There will be a guidebook to direct you how to connect.
How to intsall tip 2 - Plug in the wiruing harnss to the back of your new car stereo to install your new gizxmo or connect the positive and the negative wire from each sepaker to the positive and negative connector respectvely on the back of your sound application first.
Make sure it is connected properly and if you fail to do so, the speakers will not function at all.
How to installl tip 3 - Connect the ground wire usully the black wire of the stereo to a srcew or a bolt located near to the dashboard where the application is mounted. But make sure the wire attachment is done to a metal and not on plastic or fiberglass.
How to instakll tip 4 - Connect the 12 constant and ignition power wirees to the sysetm. You can refer to the istallation instrctions to make sure all the wires goes to the correct plzaces.
How to install a tip 5 - Slide your application into the mounting bracket that came with your stereo after you have plug the harness or the wires and then slde it into the slot in the dash. Do not screw it yet as you will need to test it first. You will find one wire connctor option on the back of your tsereo that is the option for the antenna.
How to install tip 6 - After you have performed all the above-mentioned tips, conenct the negative cable of your car to the battery. Then turn on and the power of your system, put some music and listen to all your speakes and make sure everything works. Then you can screw your car stereo into the dash.
Author Resource:-
Learn more about: LG Remarq Thank you
